Topic:
III.2.13n
Signals, which are placed according to the rules, are not operated in the signalled routes
(Author: Zebix)
Answer(s):
This behaviour could be observed if:
– The object properties of the signal contain a start delay
– The signal was in the 2D plan window in the status „stop“ and will be changed to “free” in the 2D plan window, before it is integrated into the signalled route.
Procedure:
– set the start delay in the object properties of the signal to zero for a short time. Then switch the signal to “free” and integrate it into the signalled route. Now enter the start delay again.
Alternative:
– Change to the 3D modus and switch the signal to „free“. Wait until the start delay runs out. Change now to the 2D plan window again and integrate the signal into the signalled route.
(Author: Goetz)
https://www.eepforum.de/forum/thread/6011-signale-werden-in-fahrstra%C3%9Fen-nicht-geschaltet/
Support:
Press key to get support:
– EEP Manual
– Lua Manual
– Tutorials
Remark:
Only summaries prepared by the FAQ team are given. For exact wording please refer to the linked original contributions.
The FAQ team appreciates your understanding that it could not held responsible for mistakes in the linked topics or for translation errors